Post Offer Free
Shenzhen Realan Computer Products Co.,Ltd  

Gold Index: 10454

You are here: home  > Switching Mode Power Supply  > 250W Switching Mode Power Supply

250W Switching Mode Power Supply 

Place of Origin: Guangdong, China (Mainland) 
inquire
Add to My Favorites
HiSupplier Escrow
Share |

Product Detail

Model No.: LR-1U250W


 
250W 0.6 mm SECC Switching Mode Power Supply Short-circuit P

 

250W 0.6 mm SECC Switching Mode Power Supply Short-circuit Protection

 

The Most Switch Power Supply with High Quality Realan LR-1U250W 

 

Specifications


1.overcurrent & over voltage protection
2.thermal & short-circuit protection
3.250W

 

 

Realan Switch Power LR-1U250W

 

 

 

 

1. Basic Configuration

 

1.1 Output interface: 24P (400mm), SATA+L(400mm), L+SATA(400mm), P4(400mm)

1.2 Fan: 4cm

1.3 Fan temperature control design: with

1.4 Material: 0.6SECC

1.5 Power line: 1.2m

1.6 Switchover: without

1.7 Packing: industrial packaging

 

 

2. AC Input

 

1.1 Input voltage

AC Input    Min Normal Max      Unit

Voltage 95  110      135      VAC rms

180      220      264      VAC rms

Frequency  50  ---  60  Hz

1.2 Max input current 3A (input 220V)/6A(input110V)

1.3 Max surge current 60A (220V, cold start at room temperature)

 

 

3. Power Efficiency

 

3.1 minimum 70 % (Input 220V/50Hz, full load power rating)

 

 

4. DC Output

 

Output voltage, current, ripple and noise

Voltage +5V     +12V   +3.3V  -12V    +5VSB

max load    12A      12A      7A  0.6A     2A

Full load     9A  9A  5A  0.5A     1.5A

Min load     1.0A     0.5A     0.5A     0.1A     0.1A

Regulation  ±5%    ±5%    ±5%    ±10%  ±5%

Ripple 50mV    120mV 50mV   200mV 50mV

Noise   100mV 240mV 100mV 300mV 100mV

Power supply works continuously, the DC output total power with no more than 180W, +3.3V and +5V sum of output power maximum 90 W.

 A 0.1uF ceramic disk capacitor & 10uF electrolytic (low ESR) capacitor should be put across the output terminals during ripple & noise measure. The oscilloscope bandwidth set at 20MHz with co-axial probe.

Regulation load must within 30% to 70% of maximum load.

AMBIENT TEMPERATURE 25

 

 

5. Protection

 

NOTE: due to overpower, overvoltage, under voltage, short-circuit protection movement, the power locked in shut off condition, only when these reasons remove, remote control switch at least 1 second reduction (or at least reset shut the power supply after 10 seconds), power supply can restart.

 

5.1 Short-circuit protection: the power supply will be automatic protection and close the output no matter which output terminal short circuit.

5.2 OVER LOAD PROTECTION

120-160% of maximum power

5.3 SHORT CIRCUIT PROTECTION

All output to ground

 

 

6. Time SEQ Test

 

 

6.1 POWER GOOD signal delay time (T3): 100ms ≤T3≤500ms

6.2 POWER GOOD signal rise time (T4): T4≤10ms

6.3 Hold-up Time (T5): T5≥16ms

6.4 POWER FALL signal delay time (T6): T6≥1ms

 

 

7. Remote Switch Control

 

7.1 DC output (except for +5Vsb) can be controlled by logic circuit

7.2 Logic circuit controls power supply on and off

<
bigPhoto
 Ms. Amy Ma

Tel: 86-755-26996161
Fax: 86-755-26996644
Mobile: 86- 150 1928 3250
Contact to this supplier

Related Search

Find more related products in following catalogs on Hisupplier.com

Company Info

Shenzhen Realan Computer Products Co.,Ltd [China (Mainland)]


Business Type:Manufacturer
City: Shenzhen
Province/State: Guangdong
Country/Region: China (Mainland)

You May Like: